I need help with domstic water well set ups that use a submercible pump and pressure tabk.?


Question:
I am trying to trouble shoot my domestic well system and trying to find out why I have no water pressure.from the system to the well.

Answers:
your well could be running low/shallow. Im not sure what area you live in but here in georgia the wells are just about dried up.
Your housing for the well may need an overhaul or new pump. If you are tapped into a spring you may just need to dig deeper and also you need to find out if your neighbors are getting water supply from the same vein. Had a neighbor once who was on the same vein and we had plenty of water until he grew a 5 acre garden and insisted on watering it every day rain or shine so he dug deeper and hit iron pyrite (spelling) thus rendering the water undrinkable.

Other Answers:
sounds confused ,,the pump is in the well how can it be from the system to the well thats just the output from the pump,, so take off any tubing and check for the pressure with a finger over the holes on both sides just dont run it dry as it may heat up and seize if no pressure and you have a good current like check the breackers and switches then the pump may need replaced
You must mean from the well to the system! Does the pump start? Assuming it does and nothing is coming out then you lost the prime on the pump. Probably leaky foot valve (Check valve at bottom of well). Re prime and start. If unable to start with pressure remove the foot valve at bottom of well and replace / repair it. Prime and restart.


More Questions and Answers

The consumer health information on youqa.com is for informational purposes only and is not a substitute for medical advice or treatment for any medical conditions.
The answer content post by the user, if contains the copyright content please contact us, we will immediately remove it.
Copyright © 2007 YouQA.com -   Terms of Use -   Contact us

Health Resources